Break-Thru S 240, 100 ml

Break-Thru S 240, 100 ml is an agricultural adjuvant for tank mixes that enhances the wetting on the surface of the plant and grants protection from the rain.

Benefits:
- Dynamic surface activity;
- Grants thermal and chemical stability;
- Reduces microfoam in spray systems;
- Better uptake through penetration of cuticular waxes;
- Break-Thru S240 is a very good humidifier in small doses;
- Works well in tank mix and formulations;
- Enhances soil penetration.

Action mode:
Break-thru enhances deposition of pesticides by lowering surface tension and improves spread:
- Decrease the surface tension of pesticide formulations and thereby reduce the tendency of spray droplets to bounce off plant foliage;
- Allows for better deposition and retention on plant surfaces and maximises the performance of agricultural chemical products.

Methods of application:
- For application with terrestrial equipment, higher doses of Break-Thru S240 adjuvant are recommended for combination with systemic or transamination products, and lower doses for combination with contact products.
- To prevent foaming in the tank, add the Break-Thru S240 adjuvant to the end of the mixture.
- Thus, add water in a volume of 2/3 of the tank capacity, then add plant protection products and stir the mixture.
- Add the Break-Thru S240 adjuvant, followed by the rest of the water, and mix gently.

For systemic pesticides:
Apply a maximum of 200 ml/ha;

For contact pesticides:
Apply a maximum of 125 ml/ha.
Break time is indicated by the type of products used in combination with the adjuvant.

Arable Crops:
Pesticides with systemic action to 200 ml per ha.
Pesticides with contact action to 125 ml per ha.

Horticultural crops, orchards:
200 to 300 ml per ha, depending on the stage of growth.

Compatibility:
Do not use it in combination with other adjuvants or oils, as efficiency may be affected.
It showed a very good compatibility mixed with insecticides, herbicides, fungicides, growth regulators, nutrients, and micronutrients, respecting the recommended dose and the indications present on the products. Perform a test before.

Recommendations:
Follow the recommended instruction when using in-tank mixtures.
If instructions are not available, follow the recommendations below.
Do not mix with products containing urea.
Check the compatibility labels of mixing products.
Perform a compatibility test if no mixing label information is available.