FlyPro 80W

FlyPro 80W is a professional electrical device designed to monitor and capture flying insects. It uses the synergistic effect of pheromone-impregnated adhesive board and actinic tubes that emit a special UV light over a certain wavelength to monitor and capture aphids. If the recommended steps are followed, you can achieve optimal results.

Properties & Benefits:
- made from powder coated white steel, electrostatic field
- tubes: actinic / quantum 2 x 40 W
- adhesive boards: 1 pc. inside
- coverage: 250 sqm on the wall
- install on the wall in various positions
- it targets flies, mosquitoes, flying insects
- use: for food companies
- FlyPro 80W is compatible with adhesive board PRO 40-80 Adhesive Board (PRO 40-80 Adhesive Board are purchased separately)

Useful information:
- install the device near a 220V AC power supply, grounded;
- mount the adhesive board in place (remove the protective paper from the adhesive face of the board);
- install the device about 2 metres high so you both protect it from personnel and production traffic as well as monitor and maintain it.

Other tips & recommendations:
- not to be used outdoors or in places with excess dust, cereal flour, etc.
- avoid contact with water through the electrical grille
- after the electrical connection is established, the tubes start to light up and the device is ready for operation
- use a sufficient number of devices, depending on their protected surface and depending on the configuration of the rooms, thus avoiding a mounting position that puts the device directly under the action of sunlight
- eliminate the obstacles between the device and the area to be protected, practically checking the visibility of light from all points of the area
- ensure continuous operation of the device (24 hours a day)

Please be sure to read, understand, and follow the full Conditions, Disclaimer, and Directions for Use. Use the appropriate personal safety equipment if required and when needed.