FlyPro 30W

FlyPro 30W is a professional electrical device designed to monitor and capture flying insects. It uses the synergistic effect of pheromone-impregnated adhesive board and actinic tubes that emit a special UV light over a certain wavelength to monitor and capture aphids. If the recommended steps are followed, you can achieve optimal results.

Properties & Benefits:
- made from stainless steel
- tubes: actinic / quantum 2 x 15 W
- coverage: 80 sqm on the wall
- it can be installed on the wall in various positions
- it targets flies, mosquitoes, flying insects
- use: for food companies
- FlyPro 30W is compatible with adhesive board PRO 30, ONDA 30, COM 45(Adhesive board PRO 30, ONDA 30, COM 45 are purchased separately)

Useful information:
- install the device near a 220V AC power supply, grounded;
- mount the adhesive board in place (remove the protective paper from the adhesive face of the board)
- install the device at a sufficient height to be protected from personnel and production traffic, but not too high to allow easy monitoring and maintenance (practically about 2 metres high)

Other tips & recommendations:
- not suitable for outdoor using or in places with excess dust, cereal flour, etc.
- avoid contact with water through the electrical grille
- after the electrical connection is established, the tubes start to light up and the device is ready for operation
- use a sufficient number of devices, depending on their protected surface and depending on the configuration of the rooms, thus avoiding a mounting position that puts the device directly under the action of sunlight
- eliminate the obstacles between the device and the area to be protected, practically checking the visibility of light from all points of the area
- make sure there is continuous operation of the device (24 hours a day)

Please be sure to read, understand, and follow the full Conditions, Disclaimer, and Directions for Use. Use the appropriate personal safety equipment if required and when needed.