Fly RB 40S

Fly RB 40S is a professional electro insecticide destined to monitor and capture flying insects. It works by using the synergistic effect of the adhesive board which is impregnated with pheromones, combined with the attraction of the actinic tubes that emit a special UV light on a certain wavelength that make this light attractive to insects.

Properties & Benefits:
- made from stainless steel
- tube power: 1 x 40W
- coverage area: 125 sqm
- install it on the wall in various positions
- the fixing procedure is simple

Useful information:
- Install the device near a 220V AC power supply, grounded.
- After establishing the electrical connection, the tubes start to light up and the device is ready for operation.
- Mount the adhesive board in place (remove the protective paper from the adhesive face of the board).
- Install the device about 2 metres high so you both protect it from personnel and production traffic as well as monitor and maintain it.
- Avoid putting the device directly under the action of sunlight and install a sufficient number of devices, depending on their protected surface and depending on the configuration of the rooms.
- Keep obstacles out between the device and the area to be protected, and check the visibility of light from all points of the area.
- Ensure continuous operation of the device (24 hours a day).

Other tips & recommendations:
- even though the product includes the adhesive board, it is recommended to purchase multiple boards to facilitate the continuous use of the UV trap
- it is preferred to mount it on a white wall to make the most of its reflection
- the device can be mounted suspended from the ceiling - horizontally and on the wall - horizontally
- not to be used outdoors or in places with excess dust, cereal flour, etc.
- avoid contact with water through the electrical grille

Please be sure to read, understand, and follow the full Conditions, Disclaimer, and Directions for Use. Use the appropriate personal safety equipment if required and when needed.