Fly RB 40S

Fly RB 40S is an electroinsecticide with adhesive plate for monitoring and capturing flying insects.

The Fly RB 40S electric device is designed to quickly monitor and capture flying insects. This device uses the synergistic effect of the adhesive board impregnated with pheromones, combined with the attraction due to actinic tubes that emit a special UV light on a certain wavelength that make this light attractive to insects.

Way of usage:

To obtain optimal results, the following steps will be followed:
-Do not use outdoors or in locations with excess dust, cereal flour, etc .;
-Install the device near a 220V AC power supply, grounded;
-After establishing the electrical connection, the tubes start to light up and the device is ready for operation. Also, the adhesive board must be mounted in position (remove the protective paper from the adhesive face of the board);
-Install the device at a sufficient height to be protected from personnel and production traffic, but not too high to allow easy monitoring and maintenance (practically about 2 meters high);
-Install a sufficient number of devices, depending on their protected surface and depending on the configuration of the rooms, thus avoiding a mounting position that puts the device directly under the action of sunlight;
-Avoid as much as possible the presence of obstacles between the device and the area to be protected, practically checking the visibility of light from all points of the area;
-Ensure continuous operation of the device (24 hours a day).

Installation:
The device can be mounted suspended from the ceiling - horizontally and on the wall - horizontally. The fixing procedure is simple, it is preferred to mount it on a white wall to make the most of its reflection.

Technical specifications:
-Material: stainless steel.
-Tube power: 1 x 40W.
-Coverage area: 125 sqm.
-Dimensions: 63 x 30 x 13 cm