TF-W 35 L

Manufactured by IGEBA - The Global Standard for Excellence in Thermal Fogging, the TF-W 35 L is a professional machine that features a solution system in acid resistant execution. Everything that gets in contact with the solution is made of stainless steel. The model is also available with a 10 L solution tank in stainless steel. Master of its class and the first choice of professionals this model is durable and is manufactured after international standards which makes it highly appreciated around the world.

Properties and benefits:
- Both indoors and outdoors;
- For treatment against flying insects and other pests (insecticides, acaricides, fungicides and disinfectants);
- For industrial spaces, solariums and greenhouses, warehouses;
- For areas where poor roads and tracks make it difficult to handle heavy equipment.

Technical data TF-W 35 L:
- combustion chamber power, approx. 18.7 kW (25.4 hp);
- fuel consumption, about 2l/h;
- fuel tank capacity1.2l;
- normal petrol fuel;
- working pressure in the fuel tank, approx. 0.08 bar (8,000 Pa);
- electronic ignition, power supply type 4 x 1.5 batteries (Type LR20);
- sprayed solution flow/exit,. 8-42l/hour;
- distribution nozzles 0,6-2mm;
- residual liquid in the tank if the appliance is in horizontal position approx. 0.25L;
- 10Ëš tilt down under 0.03L;
- fuel tank capacity, about 5.7 l;
- working pressure in the substance tank, about 0.25 bar (25,000 Pa);
- weight empty tank, about 7.9 kg;
- dimensions (w x h x L) 27 x 34 x 137.5 cm;
- TF 35 with standard tube of the mist substance.

The most important control elements of the standard model Igeba TF-W 35 L are:
- the air pump;
- substance tap;
- substance tank;
- start engine button:
- fuel tank;
- adjustment pin;
- stop button;
- socket with nozzle for fog substance;
- fog substance tube.

Instructions or recommendations issued by the manufacturer:
- The high gas temperature creates the optical fog effect by evaporation of certain components of the active substance solutions, for example: oils.
- The flow rate (litres/hour) varies up to 20%, according to the nature and the composition of the substances used. Because of these variations we recommend that before using the device, it is necessary to perform a volume measurement of the quantity to be sprayed. This is particularly true in the case of countries with tropical climates. When using a water based solution, use the small size nozzle of maximum 1.0 and the mist substance special tube type W (109) for water based solutions.
- Use a spraying tube that has one side opening (Schmidt Argus tube) which has a valve located on the inlet side (carburettor) and a hole for mist evacuation;
- This system with a carburettor, mixture tube, the combustion chamber and the wave tube is hereby established as an acoustic vibrations system that has a working frequency of approximately 100 Hz. Liquids can be introduced in the gas jet through the opening in the exhaust resonating tube. The high frequency of the gas tube and the high speed of the gas allow the fragmentation of the flammable and sensitive substances in the processes of chemical decomposure, without the danger of decomposure after the short intervals and remaining inside the gas stream.

Please be sure to read, understand, and follow the full Conditions, Disclaimer, and Directions for Use. Use the appropriate personal safety equipment if required and when needed.