Break Thru S 240, 2 ml

Break-Thru S240 is a polyether trisiloxane that can increase droplet spreading and dramatically reduce the surface tension of the solution therefore obtaining better crop protection and fertilization.

Way of action:
-Break-Thru S240 ensures rapid, even, and superior wetting of hydrophobic surfaces such as leaves and other parts of plants.
-The special formulation allows for better uptake of solutions through penetration of cuticular waxes and entering stomata pores.
-This process will ensure direct access to the plant's intercellular structure.
-Silicone surfactants can enhance the passage of pesticides through the cuticle without damaging it.

Advantages of solution mixed with Break-Thru S240:
- allows a larger amount of active ingredient to enter the plant;
- provides rain fastness; no need for a second treatment after one hour since rain;
- higher selectivity to crop species;
- allows the reduction of spray volumes by up to 30 %;
- compatible with various products such as herbicides, fungicides, insecticides, acaricides, plant growth regulators, and micronutrients;
- solutions can be sprayed even under hot and dry conditions, when weeds species are mature and hardened or if plants are covered with dust;
- It helps to dissolve solid formulations such as WG and WP;

Dose of application

-For pesticides with systemic action:
Apply up to 200 ml/ha in order to wetting, spreading and uptake;

-For pesticides with contact action:
Apply up to 125 ml/ha in order to improve wetting and spreading;

-For the treatments of fruit and nursery stock:
Between 200 - 300 ml/ha, depending on the growth stage.

Method of application:
-For application with terrestrial equipment, higher doses of adjuvant are recommended for combination with systemic or translaminar pesticides, and lower doses for combination with contact pesticides
-In order to prevent foam from forming in the tank mix, add the Break-Thru S240 adjuvant at the end of the mix.
-First, add water in a volume of 2/3 of the tank capacity, then add the pesticide. Shake thoroughly. Add Break-Thru S240, followed by the rest of the water, and slowly mix the solution.
-The time intervals between treatments are directly influenced by pesticides used in combination with the adjuvant.

Observation:
- Do not mix with products that contain urea (this mixture can cause burn symptoms);
- Check the label of the products to be mixed;
- Perform a compatibility test on a small area;
- Do not use in combination with other adjuvants or oils, as this may affect efficiency;
- Use the solution prepared within the time specified on the packaging of the products used in the mixture.